|
|
|
|
|
|
|
|
ACCURATE TANK SOUNDINGS HAVE NEVER BEEN EASIER.
 Before
Tank Tender, you had to rely on an old-fashioned dip stick, site glass
or electric float gauge to check the level of your boat's fuel, water
or holding tank. Not anymore.
Tank Tender provides extremely accurate readings for up to ten tanks.
Without electricity. Without leaving the bridge. Without a doubt.
Tank Tender operates on air pressure. Select the tank, then pump a small amount of air through tubing to
the bottom of the tank. When the air pressure in the tube equals the
liquid pressure at the bottom of the tank, the gauge displays this
pressure in inches of liquid.
Tank Tender's Features include: (click
here for forms)
- It's convenient.
Monitors the levels in all tanks with just one instrument.
- It's easy to use. You
can select a tank to measure and get an accurate measurement
from the bridge in two or three seconds.
- It's simple to
install. The average 4-tank system takes about an hour per tank.
And there's nothing to wire.
- It's surprisingly inexpensive.Tank Tender costs much less than
other industrial systems offering similar accuracy and
reliability.
|
|
|
|
|
|
|
|
This is the back of the 4-tank instrument. Look simple? It
is. That's because the Tank Tender was designed for maximum
reliability and accuracy and ZERO maintenance.
|
|
|
|
|
|
|
|
Tank Tender's components have proven reliability in medical and
dental applications. Only precision valves, pumps and easy-to-install
push-in connections are used.
Tank Tender gauges are available in scales of 30" or 60"
and are calibrated for inches of water and inches of diesel fuel
(other scales are available, including Metric).
As you can see by the photo, installation is a simple procedure.
All you do is drill a small hole (5/32") in the top of the tank.
Then tap with a 10x32 thread and screw the
"o" ring sealed "banjo" fitting onto the tank
top. The 1/8" nylon tubing is specially extruded to extend
straight to the bottom of the tank.
A typical 4-tank installation may read the contents of one fuel, one
holding and two water tanks. There is no chance whatsoever of
contamination because the tubing going to the tanks carries only air.
|
|
|
Tank Tender's components have proven reliability in medical and
dental applications. Only precision valves, pumps and easy-to-install
push-in connections are used.
Tank Tender gauges are available in scales of 30" or 60"
and are calibrated for inches of water and inches of diesel fuel
(other scales are available, including Metric).
As you can see by the photo, installation is a simple procedure. All
you do is drill a small hole (5/32") in the top of the tank.
Then tap with a 10x32 thread and screw the
"o" ring sealed "banjo" fitting onto the tank
top. The 1/8" nylon tubing is specially extruded to extend
straight to the bottom of the tank.
A typical 4-tank installation may read the contents of one fuel, one
holding and two water tanks. There is no chance whatsoever of
contamination because the tubing going to the tanks carries only air.
|
|
|
|
|
|
|
|
